Colin asks you this question:
"What is the best and easiest way of making a good joint on N gauge flexi track and set track. I have noticed if you undo a joint the fishplates spread to much to rejoin and make a good contact."
Comment on Colin's posting using the green comments link below.
Friday, October 24, 2008
Subscribe to:
Post Comments (Atom)
1 Comments, Feedback or Answer:
The fishlates arebeing opened up by the burr left after cutting the flexi track. Be sure to file this off paying partcular attention to the rail sides as it is this area that normally opens up the fishplate. If your fishplates have opened out at the top then the side burr is the cause. A burr on the rail base normally makes it difficult/impossible to get the fishplate on in the first place.
Post a Comment